USER’S MANUALMANUALE UTENTEwww.proel.com
10GENERAL INFORMATIONThank you for having chosen a PROEL product. HPX is a new series of PROEL power amplifi ers designed to provide to entertainers an
11englishsignal is not attenuated in any way, so is fed to the amplifi er channel at the same level at which it arrives on input).7. Channel 1 SIGNAL i
1220. Channel 2 XLR inputSame as above but for channel 2 input. It operates only in STEREO mode.21. Channel 1 JACK inputThis is a JACK female connecto
13This is the amplifi ed output of the signal applied to channel 2 input if the amplifi er is set in STEREO mode or the signal applied to channel 1 inpu
14italianoAVVERTENZE PER LA SICUREZZA• ATTENZIONE: Durante le fasi di uso o manutenzione, devono essere prese alcune precauzioni onde evitare danneg
15italianoRumore / Ronzio• Qualora possibile, usare preferibilmente solo cavi bilanciati. Cavi sbilanciati possono essere usati ma risultano rumorosi
16italianoINFORMAZIONI GENERALIGrazie per aver scelto un prodotto PROEL. HPX è una nuova serie di amplifi catori di potenza PROEL sviluppati per fornir
17italianodell'amplifi catore, in modalità BRIDGE non ha alcun effetto.L' attenuazione varia tra completamente chiuso “∞” a completamente ape
18italianoNOTA: Qualora possibile, usare sempre cavi bilanciati. Cavi sbilanciati possono essere ugualmente usati ma potrebbero dare problemi di rumor
19• PIN 2+ PIN 2- non collegati;Questa è l'uscita amplifi cata del segnale applicato all'ingresso del canale 2, se in modalità STEREO, o del
FCC COMPLIANCE NOTICEThis device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not
www.proel.comPROEL S.p.A.(World Headquarters - Factory)Via alla Ruenia, 37/4364027 Sant’Omero (TE) - ITALYTel. +39 0861 81241 Fax +39 0861 887862REV.
3INDICE / INDEXMODEL HPX900 HPX1200 HPX2400 HPX2800Power 8 ohm * 200 W 300 W 450 W 600 WPower 4 ohm * 300 W 450 W 800 W 1000 WPower 2 ohm ** 450 W 600
4SETUP AND RACK MOUNTING (FIG. 1 / 2) INSTALLAZIONE A RACK (FIG. 1 / 2)LOUDSPEAKER CABLE CAVO ALTOPARLANTEFIG. 1 / 2COLD AIRFRONTALE8U OPEN RACK10U cl
5CONNECTIONS CONNESSIONIconnectionsINPUT (ingresso)Jack (bilanciato)INPUTJack (balanced)sleeve - gndtip - hotring - coldINPUT (ingresso)XLR bilanciato
6REAR PANEL (FIG.5) PANNELLO POSTERIORE (FIG.5)CONTROL PANEL (FIG.4) PANNELLO DI CONTROLLO (FIG.4)FIG. 3 / 4HPX900HPX1200HPX2400HPX2800
7CONFIGURATION EXAMPLES (FIG.6/7/8) ESEMPI CONFIGURAZIONI (FIG.6/7/8)FIG.6FIG. 5 / 6 / 7STEREO STANDARD SETUP4 or 8 ohmloudspeakersBRIDGE SETUP8 ohm o
8SAFETY AND PRECAUTIONS• CAUTION: Before using this product read carefully the following safety instructions. Take a look of this manual entirely an
9Noise / Hum• Whenever possible, preferably use only balanced cables. Unbalanced lines may also be used but may result in noise over long cable runs.
Comments to this Manuals